Xyron and My Favourite Things partnership

I was very naughty and shared a sneak peek on social media of the gorgeous 'Delicious Birthday' stamps and the 'Sequins' steel dies. The fabulous peeps at My Favourite Things sent me the products to create a project for their partnership with Xyron this month.

I have been let off the naughty step long enough to create and share with you a 3d card.  You could also place it in a frame and give as a keepsake.  The cutting file for the cake is my own design and I created it using Silhouette Studio Designer Edition Software.

HAPPY BIRTHDAY

Supplies

Xyron Mega Runner

Xyron Glue Stick

MFT Stamps 'Delicious Birthday' Clear Acrylic 

MFT Die-namics Steel Dies 'Sequins'

DCWV Project Stack Mini Album Papers

Centura Pearl Cardstock

8x8 Kraft Card

Silhouette Studio Designer Edition

Silhouette Cameo

Ranger Archival Ink

American Crafts Ribbon

Flowers

Gems

How it's made

1. Supplies at the ready

2. Set the design up to cut

3. Cut out the cake layers

4. Emboss using a large embossing folder

5. Run adhesive down the inside of  inner strip

6. fold in the tabs ready for assembly

7. Start at the center and work to the outer edge

8. Repeat on the other side of the half circle, fold the tabs around the back to close.

9. Repeat to create the second cake half

10. put the completed cake halves to one side for later

11. Cut three layers of contrasting card stock with different edges in decreasing sizes ready to layer onto the 8 x 8 Kraft Card

12. Glue the largest base layer to the card

13. Add the medium sized layer

14. finally add the last smaller layer

15.  The card is now ready to take the cake

16. Prepare the cake plate cut file

17. Cut out using patterned cardstock (I later changed it to white)

18.  Fold in the tab along the edge, this will be used to adhere the plate to the card

19. Fold in the tabs of the plate trim

20. Apply Xyron glue along the edge of the plate base

21.  Add the trim around the edge

22. Use the mega runner to add the plate inner base (this is cosmetic to hide the tabs)

23. The tabs are now covered and ready for the plate 'legs'

24.  Apply glue to the back of the two middle 'legs'

25.  Fold the middle legs in half so the line up together, then fold the two outer legs out

26.  Glue to the underside of the cake plate, ensure it is centered and to the back

27. Adhere the cake stand to the card base, keep the bottom of the legs flush with the base of the easel card.

28. Glue the cake halves in place and add the trim and ribbon using the Xyron 1.5" Sticker Maker

29.  Create sequins using the Die-namics die

30.  Glue the mini gems to the center of the sequin cuts

31. Glue the sequins around the top edges of the two cake halves

32.  Stamp the sentiment onto white card and spray with some Diamond Spray & Sparkle

33.  Matt the sentiments onto layer of matching cardstock and tun throught the Xyron 1.5" Sticker Maker

34.  Adhere the sentiments to the cake in the centre

35. Add some flowers and embellishments

36. Finish with some gems

 Xyron products are available in the UK through Crafter's Companion

Thanks so much for stopping by today, make sure to follow Xyron on Facebook 

I'm also on facebook and if you want to stop by and say hi !

See you again soon.